Tutorial: 2013 GMC Sierra 1500 Denali Relearn Injector by Launch ThinkDiag

ThinkDiag with 16 kind of special functions:
1.Oil Reset Service
2.Steering Angle Calibration
3.Electronic Parking Brake Reset
4.Battery Register & Battery Maintenance
5.ABS Bleeding
6.Electronic Throttle Position Reset & Learn
7.Diesel Particulate Filter (DPF) Regeneration
8.Tire Pressure Monitor System Reset
9.Tooth Learning
10.Anti-theft Matching
11.Injector matching
MaEET
12.Air Suspension Reset
13. Gearbox Reset
14.Sunroof RESET
15.AFS Reset
(EGR)
16.EGR Reset

Here, we we’re going to do a fuel injector service on a GMC Denali 2013 by ThinkDiag OBD2 All system diagnostic tool

If your fuel injectors ever need to be replaced, then you can go ahead and change that with this device.



Let’s start now!

This is 2013 GMC Sierra 1500 Denali

Plug the ThinkDiag device into OBDII port inyour vehicle

Turn the ignition on

Open the ThinkDiag  APP

Go to ThinkStore->Select INJECTOR

Connecting Bluetooth…

When hear the beep that means it’s connecting to the Thinkdiag device

Select GM

It will ask to switch on ignition, we have turned on, so just click “OK” to continue

Pay attention to this info:

If the first bit of the VIN is the L letter. Please select path: CHINNESECAR->SGM. Press [OK] enter GM software. Press [Cancel] exit.

Here click “OK”

Select LD Trk, MPV, Incomplete->GMC truck->Sierra->2007-2013

Confirm the vehicle info

There are two module options:

Engine control module

Glow plug control module

Whatever we change, both the modules need to be changed.

So go to Engine Control Module firstly

If the cylinder 1 was changed out, we’ll go with selecting Cylinder 1 Injector Identifier

Follow the prompt to stop the vehicle and engine, and turn the ignition on, then click “OK”

The identifier will be directly on the part that you replace so you can get the number from there.

Performed successfully

Then can go back to cylinder 1 injector identifier to check the identifier just changed

After that, select Glow plug control module to change the identifier

The operation steps are same as the “Engine Control Module”

Job’s done!

http://www.obdexpress.co.uk/wholesale/launch-thinkdiag-obd2-code-scanner.html